Cooper M3000 Uživatelská příručka stáhnout pdf (Strana 66)

2-26 SPARC Enterprise Mx000 Servers XSCF User’s Guide • December 2010

4. Use the setdscp(8) command (see Note) to specify network interface information.

It is necessary to configure DSCP to enable it for the domains. For details about the Domain

Configuration, see Section 2.2.13, “Domain Configuration” on page 2-142.

Setting DSCP addresses can only be done when affected domains are not running. Use of the

-i and -m options to set all DSCP addresses can only be done when no domains are running.

Setting the XSCF address can only be done when no domains are running, since this would

affect the XSCF's communication to running domains. Setting individual domain addresses

can be done only if the specified domain is not running. When you changed the DSCP

address, you must reset XSCF by using the rebootxscf(8) command before domain start

up, in order to maintain the consistency between XSCF and the domain. After XSCF

resetting, the domain restart is required.

You can specify a network address for use by all of the DSCP links using the -i and -m

options. In this mode of operation, the IP addresses used by the XSCF and each

domain-specific DSCP link are automatically selected from within the range of addresses

indicated by the network address.

If you set a netmask using the -m option, this netmask value shows the mask value in the

XSCF network. A netmask value when you display the DSCP network on the domain is not

the netmask value in the XSCF network. The netmask value for the domain DSCP address,

which is displayed on the domain by using ifconfig(1M), is a value set according to the

setting of the network on the domain side.

< Example 1> Specify the entire DSCP network IP address 192.168.2.0

and netmask 255.255.255.0.

XSCF> setdscp -i 192.168.2.0 -m 255.255.255.0

<Example 2> Specify IP address 192.168.2.1 for the XSCF.

XSCF> setdscp -s -i 192.168.2.1

<Example 3> Specify the IP address of 192.168.2.2 to domain ID 1.

XSCF> setdscp -d 1 -i 192.168.2.2

<Example 4> Setting DSCP addresses using Interactive mode.

XSCF> setdscp

DSCP network [192.168.244.0 ] > 192.168.2.0

DSCP netmask [255.255.255.0 ] > 255.255.255.0

XSCF address [192.168.2.1 ] > 192.168.2.1

Domain #00 address [192.168.2.2 ] > 192.168.2.2

Commit these changes to the database? [y|n]:y

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 431 432

Žádné komentáře

Cooper M3000 Uživatelská příručka Strana 66