Cooper M3000 Uživatelská příručka stáhnout pdf (Strana 270)

4-20 SPARC Enterprise Mx000 Servers XSCF User’s Guide • December 2010

3. Confirm ok prompt on the specified domain console.

Note – To send the break signal to the domain, the domain mode setting is required. When

the mode switch on the operator panel is set to Service, the automatic boot and host

watchdog functions are suppressed and the break signal is received, regardless of the domain

mode settings. For details of the domain mode settings, see Section 2.2.15, “Domain Mode

Configuration” on page 2-173.

4.4.8 Air-Conditioning Wait Time Administration

The air-conditioning wait time is intended to prevent the server from performing power-on

processing until the room temperature environment is prepared by air-conditioning facilities.

Once the air-conditioning wait time is set, the server will start power-on processing after its

power is turned on and the set air-conditioning time elapses.

■ Command operation

1. Use the showpowerupdelay(8) command to display the air-conditioning wait time

(wait time).

2. Use the setpowerupdelay(8) command to set the air-conditioning wait time. Set

the air-conditioning wait time from 0 to 255 (min). The default is "0 min."

3. Use the showpowerupdelay(8) command to confirm the setting. Also, to apply the

setting, turning on the server power supply.

4. Confirm whether the setting time is valid when turning on the server power supply

the next time, by checking the time from when you perform the power on till when

the power supply unit is actually turned on.

XSCF> showpowerupdelay

warmup time : 10 minute(s)

wait time : 20 minute(s)

<Example> The air-conditioning wait time is set to 15 min.

XSCF> setpowerupdelay -c wait -s 15

XSCF> showpowerupdelay

warmup time : 10 minute(s)

wait time : 15 minute(s)

1 2 ... 265 266 267 268 269 270 271 272 273 274 275 ... 431 432

Žádné komentáře

Cooper M3000 Uživatelská příručka Strana 270