Cooper M3000 Uživatelská příručka stáhnout pdf (Strana 45)

100

101

Chapter 2 Setting Up XSCF 2-5

■ When the system time is updated, the XSCF reset is done and the XSCF session is

disconnected. Please log in again to the XSCF using the new user account.

■ NTP settings (setntp(8)) are done after the Network settings or the Domain

Configuration.

5. Configure the SSH/telnet settings.

■ XSCF reset is required to enable SSH, to disable telnet, and to set the SSH access control

from domain. Go to the next step when you reset it later. If you want to reset XSCF

immediately, use the rebootxscf(8) command. After the XSCF reset, the XSCF session

is disconnected. Log in again to the XSCF.

■ You can enable SSH and telnet at the same time. However, the telnet connection is not a

secure connection protocol. We recommend that when you enable SSH that you disable

telnet.

6. Confirm the XSCF host public key.

■ Before using SSH for XSCF-LAN connection, record the fingerprint. Or, copy the text

data of the host public key and save the data to a specific directory of the client. (The

following screen is an example.)

• Select SSH or telnet, and set SSH access control

from domain.

setssh(8), settelnet(8),

• Display and specify the timeout monitoring period. showautologout(8),

setautologout(8)

(See Section 2.2.7, “SSH/Telnet

Administration” on page 2-101)

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 431 432

Komentáře k této Příručce

Žádné komentáře

Cooper M3000 Uživatelská příručka Strana 45

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Cooper M3000