Cooper M3000 Uživatelská příručka stáhnout pdf (Strana 43)

Chapter 2 Setting Up XSCF 2-3

Note – Establish one-to-one communication between the PC and XSCF during the initial

setup.

1. Connect to XSCF by serial connection and log in.

To configure XSCF, the system administrator or a field engineer first uses the XSCF

default user account. Before an appropriate user account for the user environment is

created, log in with the following default user account and password:

■ Default user account: default

The user privileges are useradm, platadm.

■ Default password:

The default password is not input directly on the keyboard. Instead, after the default

user account is input, the mode switch of the operator panel is operated as follows.

a. If Locked, change to Service. (Or if Service, change to Locked)

b. Press return. Keep the status for more than 5 seconds.

c. Change to Locked. (Or change to Service)

d. Press return.

This mode switch operation is done within one minute. When one minute is passed, the

authentication timeout occurs.

■ To begin the configuration, connect the XSCF Shell over a serial connection using any

terminal software. The shell can be used immediately following connection to the

serial port.

■ Log in with the default user account. Follow the instructions to change the mode

switch of the operator panel, and operate the mode switch within one minute.

When the server is running normally, the mode switch is set to the Locked position.

Change the panel mode switch to Service and press return...

(Operation : Locked state -> Service -> Return)

Leave it in that position for at least 5 seconds. Change the panel

mode switch to Locked, and press return...

(Operation : Wait more than 5 seconds -> Service state ->

Locked -> Return)

XSCF>

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 431 432

Žádné komentáře

Cooper M3000 Uživatelská příručka Strana 43