Cooper 9448ES Servisní příručka stáhnout pdf (Strana 27)

496574 27

Zone 6 50 R 0 R Normal Alarm

1 R PA

Prog O/P 51 R 0 R PIR set latch

1 R Shock reset

Zone 1 in Part Set 52 R 0 R Entry Route

1 R Entry/Exit

Part Set Alarm 53 R 0 R Full Alarm

Response 1 R Internal sounder

Zone 3 54 R 0 R Normal Alarm

1 R Entry/Exit

Zone 5 55 R 0 R Normal Alarm

1 R Fire

30-second 64 R 0 R Enabled

Dual Ply 1 R Disabled

Keypad 1 & 3 PA 68 R 0 R Disabled

1 R Enabled

View Log 90 R Press << to see earlier

events, >> for later events.

Walk Test 97 R Trigger detectors. Press O to exit test.

Load Defaults 98 R Does not change access

codes

Leave Program 99 R (See note 5.)

Notes:

1. n..n = the numbers of the zones. Key the zone number to toggle the zones

on or off. Pressing

stores the zones selected. You cannot omit Entry/Exit

zone(s) in Full or Part set.

2. Program any zones not connected as "Not used".

3. The end user may change the user codes (see separate user guide).

4. Default user code 2 "0000" is inactive. Changing user code 2 back to "0000"

at any time makes the code inactive again.

5. If the internal sounder activates when you use this command then check the

lid tamper, bell tamper, and the global zone anti tamper.

To Re-enter Programming Mode

You can re-enter programming mode at any time when the panel is not set or

in alarm:

Key-in 0 then R followed by the engineer access code.

All LEDs, except for Power, flash.

You are now in programming mode.

4. Programming

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 59 60

Žádné komentáře

Cooper 9448ES Servisní příručka Strana 27