Cooper 9448ES Servisní příručka stáhnout pdf (Strana 25)

496574 25

4. PROGRAMMING

When supplied from the factory the panel is already programmed with a set

of default options. These are listed below.

Factory Default Programming

Feature default To change use

command:

Zones omitted in part set none 10

Chime none 11

Zones Not Used none 15

Engineer code 7890 20

User code 1 1234 21

User code 2 0000 (inactive until changed) 22

Silent Part Set No 35

Zone 2 Normal Alarm 36

Auto Rearm Never 40

Bell time 20 minutes 42

Entry time 20 seconds 43

Exit time 10 seconds 44

Zone 6 Normal Alarm 50

Prog O/P PIR set latch 51

Zone 1 in Part Set Entry Route 52

Part set alarm response Full Alarm 53

Zone 3 Normal Alarm 54

Zone 5 Normal Alarm 55

Dual Ply Enabled 64

Keypad 1 & 3 PA Disabled 68

Changing Default Programming

To change the factory defaults, the panel must be in programming mode.

Then:

1. Key in a two digit programming command followed by "R". (See "Engi-

neer Program Command List".)

On commands 35 to 68 a LED will glow to show you the current option

used in the command. If the LED is OFF the option is "0".

2. Key in the correct digit for the option you want, and then press R.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 59 60

Žádné komentáře

Cooper 9448ES Servisní příručka Strana 25